HIKVISION DS-2CD6986F-H User Manual

User Manual of PanoVu Series Network Camera
70
Note:
You need a FTP server and set FTP parameters first. Refer to Section 2.2.2 Advanced Settings -
Configuring FTP Settings for setting FTP parameters.
 Trigger Channel
Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section 5.1 Storage
Settings for settings the recording schedule.
 Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
Note:
To trigger an alarm output when an event occurs, refer to Section 6.1.5 Configuring Alarm
Output to set the alarm output parameters.
6.1.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the video tampering settings interface:
Configuration > Event > Basic Event > Video Tampering
Figure 6-7 Tampering Alarm
2. Check the Enable checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 4 in Section 6.1.1 Configuring Motion Detection.

HIKVISION DS-2CD6986F-H Specifications

General

Brand	HIKVISION
Model	DS-2CD6986F-H
Category	Security Camera
Language	English