HIKVISION DS-2SF8C442MXG-EL/26 - Set SRTP

Data Plan
Enter the amount of usable data and select the unit.
Pre-Alarm Threshold
When the used data reaches the set percentage of data plan, the device sends an alarm
message, and shows nocaon on the OSD or pop-up window.
4.
Select Normal Linkage.
If Send Email or
Nofy Surveillance Center is selected, the device sends an alarm message by
Email or to surveillance center when the used data reaches the threshold.
5.
Click Save.
Note
The funcon varies with dierent device models.
10.15 Set SRTP
The Secure Real-me Transport Protocol (SRTP) is a Real-me Transport Protocol (RTP) internet
protocol, intended to provide encrypon, message authencaon and integrity, and replay aack
protecon
to the RTP data in both unicast and mulcast applicaons.
Steps
1.
Go to
Conguraon → Network → Advanced Sengs → SRTP .
2.
Select Server Cercate.
3.
Select Encrypted Algorithm.
4.
Click Save.
Note
●
Only certain device models support this funcon.
●
If the funcon is abnormal, check if the selected cercate is abnormal in cercate
management.
TandemVu PTZ Camera User Manual
115