HIKVISION DS-2SF8C442MXG-EL/26 - Set Device Position

Note
More calibraon points may increase calibraon accuracy, but more focusing me is required.
The default amount is recommended.
3.
Select the scene to display the calibraon line.
A red line displays on live image.
4.
Adjust the length and
posion of the line by dragging its two endpoints.
Note
The red line is recommended to stay in the center of the scene and to cover ground at the same
me.
Double click the image to enter full screen mode.
5.
Click Start Calibraon.
Calibraon status displays on the live image.
6.
Repeat to add other scenes and complete the
calibraon.
7.
Check Enable Height Compensaon if the mounng height of the device is lower than 3 meters.
8.
Check Enable aer successful calibraon.
9.
Click Save.
4.14 Set Device
Posion
Before You Start
Go to
Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Use other direcon indicang devices to nd the North at the device locaon.
Steps
1.
Go to Conguraon → PTZ → Posion Sengs .
2.
Set compass.
1) Adjust the
lt posion of the device to 0 by controlling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan
posion to show the live view of the north direcon by controlling the le
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3.
Click Gyroscope Atude Calibraon to calibrate gyroscope.
Note
Only the device with built-in gyroscope supports this funcon.
4.
Get the device locaon informaon in advance, and input the longitude and latude of the
device manually.
5.
Set vandal-proof alarm.
The
funcon enables the device to trigger alarms when its posion changes because of shock or
vandalism.
TandemVu PTZ Camera User Manual
53