Name: HIKVISION DS-2SF8C442MXG-EL/26
Brand: HIKVISION
Rating: 4 (1 reviews)

To Next Page

To Previous Page

4.11 Set Power O Memory

This funcon can resume the previous PTZ status of device aer it restarng from a power-o.

Steps

Go to

Conguraon → PTZ → Basic Sengs .

Select Resume Time Point. When the device stays at one posion for the set resume me point

or more, the

posion is saved as a memory point. The device returns to the last memory point

when it restarts.

Click Save.

4.12 Set PTZ Priority

The funcon can set the PTZ priority of dierent signals.

Steps

Go to

Conguraon → PTZ → Priorize PTZ .

Set the priority signal and delayed me.

Network

The network signal controls the device with priority.

RS-485

The RS-485 signal controls the device with priority.

Delay

It refers to the

me interval of PTZ operaon controlled by dierent signals. When the

operaon with high priority is nished, the low priority signal controls the device aer the

seng interval.

Click Save.

4.13 Set Rapid Focus

Rapid focus is a funcon to reduce me of focusing comparing with that of normal focusing. To use

the funcon, calibraon should be done rst. Rapid focus may not be supported by certain device

models.

Steps

Go to

Conguraon → PTZ → Rapid Focus .

Add scenes for calibraon.

1) Adjust the live image to a desired scene via PTZ control buons, and click Add.

2) Set the Rate and the Calibraon Point Amount of the added scene.

TandemVu PTZ Camera User Manual

Questions and Answers:

Need help?

Do you have a question about the HIKVISION DS-2SF8C442MXG-EL/26 and is the answer not in the manual?

HIKVISION DS-2SF8C442MXG-EL/26 Specifications

General