10
field will select all items on the list. In PTZ Control mode, it will turn on/off PTZ light.
• 3DEF/F2: (1) Enter numeral “3”; (2) Enter letters “DEF”; (3) The F2 button is used to cycle
through tab pages. It will also bring up the Channel & OSD Position settings.
• 4GHI/ESC: (1) Enter numeral “4”; (2) Enter letters “GHI”
(3) Exit and back to the previous menu
• 5JKL/EDIT: (1) Enter numeral “5”; (2) Enter letters “JKL”; (3) Delete characters before cursor;
(4)Select the checkbox and ON/OFF switch; (5) Start/stop record clipping in playback
• 6MNO/PLAY: (1) Enter numeral “6”; (2) Enter letters “MNO”;
(3) Playback, for direct access to playback interface
• 7PQRS/REC: (1) Enter numeral “7”; (2) Enter letters “PQRS”; (3) Manual record, for direct
access to manual record interface; manually enable/disable record
• 8TQV/PTZ: (1) Enter numeral “8”; (2) Enter letters “TQV”; (3) Access PTZ control interface
• 9WXYZ/PREV: (1) Enter numeral “9”; (2) Enter letters “WXYZ”; (3) Multi-camera display in
preview
• 0/A: (1) Enter numeral “0”; (2) switch between input methods (upper and lowercase alphabet,
symbols and numeric input)
3. SHIFT: Switch of compound keys between the numeric/letter input and functional control.
4. Control Buttons:
• Directional buttons: In menu mode, the direction buttons are used to navigate between different
fields and items and select setting parameters. In playback mode, the Up and Down buttons are
used to speed up and slow down record play, and
the Left and Right buttons are used to select the
recording 30s forwards or backward
s. In preview mode, these buttons can be used to cycle through
channels.
• Enter: The Enter button is used to confirm selection in menu mode; or used to select checkbox
fields and ON/OFF switch. In playback mode, it can be used to play or pause the video. In
single-frame play mode, pressing the Enter button will advance the video by a single frame. And
in auto sequence preview mode, the buttons can be used to pause / resume auto sequence.
5. Status Indicators:
• POWER: the POWER indicator turns green when DVR is powered up.
• STATUS: the indicator lights when the compound key switches to numeric/letter input mode.
• Tx/Rx: TX/RX indictor flickers green when network connection is functioning normally.
6. IR Receiver: operation by IR remote control.
IRRemoteControl
Your DVR may also be controlled with the included IR remote control, shown in Figure 2.
Batteries (2×AAA) must be installed before operation.
To Next Page
Loading...
Need help?
General