73
Figure 2. Camera Enabled Status Menu
Uncheck the checkbox to disable corresponding camera. Click OK to save settings. A confirmation
message then will appear on the screen asking you to reboot the DVR. Click Yes to reboot the unit.
After the system has rebooted, enter the Camera Management menu to continue with the following
steps.
3.
Select the Add button to enter IP Channel Settings menu, shown in Figure 3.
Figure 3. IP Channel Settings Menu
4. Select the IP device from the list. The devices found in the list are those supported by SADP and are
found by the DVR. If no devices were found, you may manually enter the camera parameters in the
fields below.
5. Configure IP camera settings, including IP address, ports, user name and password of the IP camera.
Note:
The default user name for IP camera is admin; other user names are allowable.
6. Select OK to save settings and return to the Camera Management menu.
7. If the IP camera has been added successfully, the Status for that camera will be displayed Connected
(Figure 4). If not, click the Set button to check that the parameters were entered correctly. You may
also delete an added channel by clicking the Delete button.
Note:
DS-7604NI-S/M and DS-7604NI-S models provide no analog camera connection; please
select IP cameras for configuration.
To Next Page
Loading...
