HIKVISION DS-7608NI-L1/W

Select the output to show event video.
Alarm Pop-up Delay
Set the me in seconds to show alarm event image. If alarms are triggered simultaneously in
several channels, their full-screen images will be switched at an interval of 10 seconds
(default dwell me).
3. Click Linkage Acon of the alarm detecon.
4. Select Alarm Pop-up Window alarm linkage acon.
5. Select the channel(s) in Trigger Channel sengs you want to make full screen monitoring.
Note
Auto-switch will terminate once the alarm stops and back to the live view interface.
Congure Buzzer Alarm
The audio warning enables the video recorder to trigger an audible beep when an alarm is
detected.
Steps
1. Go to
Conguraon → System → Live View → General .
2. Turn on Audio, and set Volume.
3. Go to Linkage
Acon interface of the alarm detecon.
4. Select Buzzer Alarm linkage acon.
Nofy
Surveillance Center
The video recorder can send an excepon or alarm signal to the remote alarm host when an event
occurs. The alarm host refers to the computer installed with client soware (e.g., iVMS-4200,
iVMS-5200).
Steps
1. Go to
Conguraon → Network → General → More Sengs .
2. Set Alarm Host IP and Alarm Host Port.
3. Go to Linkage
Acon interface of the alarm detecon.
4. Select Nofy Surveillance Center.
Congure
Email Linkage
The video recorder can send an email with alarm informaon to a user or users when an alarm is
detected.
Steps
1. Go to Conguraon → Network → Email .
2.
Congure the sengs.
Network Video Recorder User Manual
68