HIKVISION DS-K1T341B Series - Page 62

Figure 6-13 Access Control Parameters
The available parameters descripons are as follows:
Table 6-2 Access Control Parameters
Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
• Only the device with the
ngerprint module supports the
ngerprint related funcon.
• Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use
mulple authencaon modes.
• If you adopt
mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
DS-K1T341B Series Face Recognion Terminal User Manual
46