HIKVISION DS-K1T341B Series User Manual

Figure 7-6 TCP/IP Sengs Page
Click Save to save the sengs.
NIC Type
Select a NIC type from the drop-down list. By default, it is Auto.
DHCP
If uncheck the
funcon, you should set the IPv4 address, IPv4 subnet mask, IPv4 default
gateway, MTU, and the device port.
If you check the funcon, the system will allocate the IPv4 address, IPv4 subnet mask, and the
IPv4 default gateway
automacally.
DNS Server
Set the preferred DNS server and the Alternate DNS server according to your actual need.
Set EHome Parameters
Set the EHome parameters for accessing device via EHome protocol.
Steps
Note
The funcon should be supported by the device.
1. Click Conguraon → Network → Advanced Sengs → Plaorm .
2. Select EHome from the plaorm access mode drop-down list.
3. Check Enable.
4. Set the EHome version, server address, device ID, and the EHome status.
Note
If you select 5.0 as the version, you should set the EHome key as well.
5. Click Save.
DS-K1T341B Series Face Recognion Terminal User Manual
63

HIKVISION DS-K1T341B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341B Series
Category	Touch terminals
Language	English