HIKVISION DS-K1T341B Series

7. Improper replacement of the baery with an incorrect type may defeat a safeguard (for
example, in the case of some lithium baery types).
8. Do not dispose of the baery into re or a hot oven, or mechanically crush or cut the baery,
which may result in an explosion.
9. Do not leave the
baery in an extremely high temperature surrounding environment, which
may result in an explosion or the leakage of
ammable liquid or gas.
10. Do not subject the baery to extremely low air pressure, which may result in an explosion or
the leakage of ammable liquid or gas.
11. Dispose of used
baeries according to the instrucons
• This equipment is not suitable for use in locaons where children are likely to be present.
• This equipment is for use only with DS-K1T341
mounng plate, bracket. Use with other (carts,
stands, or carriers) may result in instability causing injury.
• To prevent possible hearing damage, do not listen at high volume levels for long periods.
Cauons:
• No naked ame sources, such as lighted candles, should be placed on the equipment The USB
port of the equipment is used for
connecng to a mouse, a keyboard, or a USB ash drive only.
• The serial port of the equipment is used for debugging only.
• Burned ngers when handling the back panel. Wait one-half hour aer switching o before
handling the parts.
• Do not drop the device or subject it to physical shock, and do not expose it to high
electromagnesm radiaon. Avoid the equipment installaon on vibraons surface or places
subject to shock (ignorance can cause equipment damage).
• Install the equipment according to the
instrucons in this manual. To prevent injury, this
equipment must be securely
aached to the oor/wall in accordance with the installaon
instrucons.
• Do not place the device in extremely hot (refer to the specicaon of the device for the detailed
operang temperature), cold, dusty or damp locaons, and do not expose it to high
electromagnec radiaon.
• The device cover for indoor use shall be kept from rain and moisture.
• Exposing the equipment to direct sun light, low venlaon or heat source such as heater or
radiator is forbidden (ignorance can cause
re danger).
• Do not aim the device at the sun or extra bright places. A blooming or smear may occur
otherwise (which is not a
malfuncon however), and aecng the endurance of sensor at the
same me.
• Please use the provided glove when open up the device cover, avoid direct contact with the
device cover, because the acidic sweat of the
ngers may erode the surface coang of the device
cover.
• Please use a
so and dry cloth when clean inside and outside surfaces of the device cover, do
not use alkaline detergents.
• Please keep all wrappers
aer unpack them for future use. In case of any failure occurred, you
need to return the device to the factory with the original wrapper. Transportaon without the
original wrapper may result in damage on the device and lead to addional costs.
DS-K1T341B Series Face Recognion Terminal User Manual
vii