Video Access Control Terminal User Manual
6
3 Installation
Before You Start:
Make sure that the device in the package is in good condition and all the assembly parts are included.
Make sure that the wall is strong enough to withstand three times the weight of the terminal.
Set the DIP address before installation.
Steps:
1. Connect the cables with the connecter on the
rear panel of the device. Route the cables
through the cable hole of the mounting plate.
The cable holes are on the right side, left side
and lower side of the rear cover. If the
right/left side cable hole is selected, remove
the plastic sheet of the cable hole.
2. Secure the mounting plate on the wall with 4
supplied screws.
3. Connect the corresponding cables.
4. Push the terminal in the mounting plate from
bottom up.
5. Tighten the screws on the bottom of the
terminal to fix the terminal on the mounting
plate and complete the installation.
To Next Page
Loading...
