HIKVISION DS-K1T500S - Indicator and Buzzer Description

Video Access Control Terminal User Manual
132
9.3 Indicator and Buzzer Description
Power on after 10s, the buzzer will beep once. When the device is powered on, the buzzer will beep again (once).
The indicator will remain red in this duration.
The buzzer descriptions are as follows:
Type
Description
Beep Once
Card Swiping
Pressing Button
After Card Swiping and before Scanning Fingerprint in Multiple
Authentications
Fast Beep Twice
Valid Card Swiping
Slow Beep for Three Times
Invalid Card Swiping
Rapid and Continuous Beep
Tampering Alarm
Buzzer Alarm
Slow and Continuous Beep
Not Encrypted Card Reader
The card reader indicator descriptions are as follows:
Indicator
Description
Flashing Green Once and Flashing Red for 3
Times
Powering On
Continuous Flashing Green
After Card Swiping and before Scanning Fingerprint in
Multiple Authentications
Solid Green for 3s
Fingerprint Authentication Completed after Swiping
Card in Card Swiping Operation/Multiple
Authentications
Solid Red
Working Properly
Flashing Red for 3 Times
Invalid Card Swiping
Continuous Flashing Red
Card Reader Mode Offline and Registration Failure