Video Access Control Terminal User Manual
45
Note: The port number of the wireless network and wired network should be consistent with the port number of
EHome.
Wireless Communication Center Settings
Steps:
1. Click the Wireless Communication Center Settings tab.
2. Select the APN name as CMNET or UNINET.
3. Input the SIM Card No.
4. Select the center group in the dropdown list.
5. Input the IP address and Port No.
6. Select the protocol type as EHome. The default port No. for EHome is 7660.
7. Set an account name for the network center. A consistent account should be used in one platform.
8. Click Save button to save parameters.
Note: The port number of the wireless network and wired network should be consistent with the port number of
EHome.
7.3.3 Capture Settings
In the Edit Access Controller interface, select the access control device and click Capture Settings button to enter
the capture settings interface. You can set the parameters of capture linkage and manual capture.
Notes:
The Capture Settings should be supported by the device.
Before setting the capture setting, you should configure the storage server for picture storage. For details,
refer to 8.4.4 Storage Server Configuration.
Linked Capture
Steps:
1. Select the Linked Capture tab.
To Next Page
Loading...
