Video Access Control Terminal User Manual
47
You can set the RS-485 parameters including the baud rate, data bit, the stop bit, parity type, flow control type,
communication mode, work mode, and connection mode.
Note: The RS-485 Settings should be supported by the device.
Steps:
1. In the Edit Access Controller interface, select the access control device and click the RS-485 Settings button
to enter the RS-485 Settings interface.
Note: The RS-485 Settings button is available when the device supports RS-485 port.
2. Select the serial No. of the port from the dropdown list to set the RS-485 parameters.
3. Set the baud rate, data bit, the stop bit, parity type, communication mode, work mode, and connection
mode in the dropdown list.
4. Click Save to save the settings and the configured parameters will be applied to the device automatically.
7.3.5 Door Group Management
After adding the access control device, you can add the access control points (doors ) to different groups to
realize the centralized management.
Click icon on the control panel to enter the Door Group Management interface.
To Next Page
Loading...
