HIKVISION DS-K1T500S - The Wiring of Wiegand; The Wiring of RS-485 Output

Video Access Control Terminal User Manual
11
5.3.1 The Wiring of Wiegand
 When the access control terminal works as a card reader, you must the WG_ERR, BUZZER and WG_OK
interfaces if you want to control the LED and buzzer of the Wiegand card reader.
 Set the working mode of the terminal as card reader, if the terminal is required to work as a card reader. The
card reader mode support to communicate by Wiegand or RS-485.
 The distance of Wiegand communication should be no longer than 80 m.
 The external power supply and the access control terminal should use the same GND cable.
5.3.2 The Wiring of RS-485 Output
 Set the working mode of the terminal as card reader, if the terminal requires working as a card reader.
 When the access control terminal works as a RS-485 card reader, the default RS-485 address is 1.