Video Access Control Terminal User Manual
43
Operating Trigger
Steps:
1. Click Operation -> Trigger. You can check the trigger status.
2. Check the trigger and click Open or Close to open/close the trigger.
Checking Status
Click Status -> Alarm or Status -> Trigger to check the trigger status.
7.3.2 Network Settings
In the Edit Access Controller interface, select the access control device and click Network Settings button to
enter the Network Settings interface. You can set the uploading mode, and set the network center and wireless
communication center.
Uploading Mode Settings
Steps:
1. Click the Uploading Mode Settings tab.
To Next Page
Loading...
