Video Access Control Terminal User Manual
44
2. Select the center group in the dropdown list.
3. Check the Enable checkbox to enable the selected center group.
4. Select the report type in the dropdown list.
5. Select the uploading mode in the dropdown list. You can enable N1/G1 for the main channel and the backup
channel, or select off to disable the main channel or the backup channel.
Note: The main channel and the backup channel cannot enable N1 or G1 at the same time.
6. Click Save button to save parameters.
Network Center Settings
You can set the account for EHome protocol in Network Settings tab page. Then you can add devices via EHome
protocol.
Steps:
1. Click the Network Center Settings tab.
2. Select the center group in the dropdown list.
3. Select an address type in the dropdown list.
4. Input IP address and port No. For EHome protocol, the default port No. for EHome is 7660.
5. Select the protocol type as EHome.
6. Set an account name for the network center.
Note: The account should contain 1 to 32 characters and only letters and numbers are allowed.
7. Click Save button to save parameters.
To Next Page
Loading...
