Video Access Control Terminal User Manual
99
2. Select the device type.
Currently, the supported fingerprint machine types include DS-K1F800-F, DS-K1F300-F, and DS-K1F810-F.
3. For fingerprint machine type DS-K1F800-F, you can set the serial port number, baud rate, and overtime
parameters of the fingerprint machine.
4. Click Save button to save the settings.
You can click Restore Default Value button to restore the default settings.
Notes:
The serial port number should correspond to the serial port number of PC.
The baud rate should be set according to the external fingerprint card reader. The default value is 19200.
Overtime refers to the valid fingerprint collecting time. If the user does not input a fingerprint or inputs a
fingerprint unsuccessfully, the device will indicate that the fingerprint collecting is over.
Storage Server Configuration
You should configure the storage server before capturing the pictures for the storage of captured pictures.
Steps:
1. Click Tool->Storage Server on the menu to enter the storage server configuration interface.
2. Input the storage server parameters including IP address, port No., user name, and password.
3. Click Configure button to enter the Remote Configuration interface as follows.
To Next Page
Loading...
