HIKVISION DS-K1T500S - Page 123

Video Access Control Terminal User Manual
119
and the status of the formatted HDD changes from Unformatted to Normal Status.
Note: Formatting the HDDs is to pre-allocate the disk space for storage and the original data of the formatted
HDDs will not be deleted.
SAN and CVR Configuration
Purpose:
Client provides SAN configuration and CVR configuration to conveniently set the logical volume and CVR function
for CVR device. For detailed introduction about SAN configuration and CVR configuration, refer to the User
Manual of the CVR.
Note: This function should be supported by the device.
Select the added CVR from the list and click CVR Configuration or SAN Configuration.
Configuring Storage Schedule
Before you start:
The storage server needs to be added to the client software and the HDDs need to be formatted for the video file
storage.
Steps:
1. Open the Storage Schedule page.
2. Select the camera from the Camera Group list.
3. Select the storage server from the Storage Server drop-down list.
Note: You can click Storage Server Management to add, edit or delete the storage server.
4. Check the checkbox Recording Schedule to enable storing the video files.
You can also check the checkbox Picture Storage to store the alarm pictures of the camera when event
occurs.
For the network cameras with the function of heat map or people counting, the Additional Information
Storage checkbox is available. You can click VCA Config to set the VCA rule for the camera, and check the
Additional Information Storage checkbox and the heat map, people counting data and road traffic data will
be uploaded to the storage server.
Note: For detailed configuration about setting the VCA rule, please refer to the User Manual of the camera.
5. Select the schedule template for recording from the drop-down list.
If you need to edit or customize the template, see Configuring Recording Schedule Template.
6. Click Advanced Settings to set the pre-record time, post-record time and other parameters for recording.
7. Click Set Quota to enter the HDD management interface of the storage server. You can set the corresponding
quota ratio for record, picture and additional information.
Example: If you set the record quota as 60%, then the 60% of the storage space can be used for storing the
video files.
8. Click Save to save the settings.