Video Access Control Terminal User Manual
39
3. Select the storage mode.
4. Click Save to save the settings.
Configuring Trigger Parameters
Steps:
1. Click Alarm -> Trigger. You can check the trigger parameters.
2. Click the icon to enter the Trigger Parameters Settings window. You can configure the trigger name and
the output delay.
3. Click Save to save the paramters.
4. (Optional) Click Copy to… to copy the trigger information to other triggers.
Configuring Access Control
In the Remote Configuration interface, click Other -> Access Control Parameters. Check Superimposed user
information, Enable voice prompts, Upload picture to capture whether the linkage, Save Linked Captured
Pictures, Whether to allow key input card number, Enable WiFi detect, and Enable 3G/4G. Click Save to save
the settings.
To Next Page
Loading...
