Video Access Control Terminal User Manual
60
2. In the pop-up window, click and select another card in the popup window to replace the current card.
3. Click OK to save the changes.
Note: After changing the card, the original card will turn to empty card and you can find it in the Empty Card tab
page.
Returning Card
You can return the card from normal card to empty status and cancel the linkage between the card and the
person.
Steps:
1. Check the checkbox to select an issued card and click Return Card button to cancel the assotiation of the
card.
2. Click OK to comfirm the operation.
Then the card will disappear from the Normal Card list, and you can find it in the Empty Card list.
Reporting Card Loss
Steps:
1. Check the checkbox to select an issued card and click Report Card Loss button to set the card as the Lost
Card, that is, an invalid card.
2. Click OK to comfirm the operation.
Then the card will disappear from the Normal Card list, and you can find it in the Lost Card list.
Setting Card Password
Steps:
1. Check the checkbox to select an issued card and click Set Password button to set the password for the card.
2. Input the card password and confirm the password. The card password should contain 4 to 8 digits.
3. Click OK to save the settings.
Note: The password will be required when the card holder swiping the card to get enter to or exit from the door
if you enable the card reader authentication mode of Card and Password, Password and Fingerprint, and Card,
Password, and Fingerprint. For details, refer to 4.7.2 Card Reader Authentication.
Importing and Exporting Cards
Steps:
1. To import the card and person information from the local PC, click Import button to pop up the following
dialog box.
To Next Page
Loading...
