HIKVISION DS-K1TA70 Series

Note
The picture should be in JPG or JPEG format and smaller than 200 KB.
6.
Oponal: Enable Verify by Device to check whether the facial recognion device managed in
the client can recognize the face in the photo.
Note
This funcon is hidden or shown according to the device capacity.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
9.4.5 Take a Photo via Client
When adding a person, you can take a photo of the her/him via the client and set this photo as the
person's
prole.
Before You Start
Make sure PC running the client has a camera or you have connected other USB camera to the PC.
Steps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the person and click Add to enter Add
Person window.
Note
Enter the person's basic informaon rst. For details, refer to Congure Basic Informaon .
3.
Click Add Face in the Basic Informaon area.
4.
Select Take Photo to enter Take Photo window.
5.
Oponal: Enable Verify by Device to check whether the captured face photo can meet the
uploading requirements.
Note
This funcon is hidden or shown according to the device capacity.
6.
Take a photo.
1) Face to the camera and make sure your face is in the middle of the collecng window.
2) Click
to capture a face photo.
3) Oponal: Click to capture again.
4) Click OK to save the captured photo.
DS-K1TA70 Series Face Recognion Terminal User Manual
119