HIKVISION DS-K1TA70 Series

9.14.6 Security Mode Sengs
Set the security mode for logging in the client soware.
On the Device for Management page, click → System → Security to enter the Security Mode
tab.
Select a security mode from the drop-down list, and click Save.
You can also enable SSH to get a more secure network.
Security Mode
High security level for user informaon vericaon when logging in the client soware.
Compable Mode
The user informaon vericaon is compable with the old client soware version when
logging in.
9.14.7 Network Parameters
Sengs
Set device network parameters, including the NIC type, DHCP, and HTTP.
On the Device for Management page, click
→ Network → Network Parameters to enter the
Network Parameters Sengs tab.
NIC Type
Select a NIC type from the drop-down list. You can select either
Self-adapve, 10M, or 100M.
DHCP
If you disable the funcon, you should manually set the device's IPv4 address, IPv4 subnet
mask, IPv4 default gateway, MTU, and port.
If you enable the
funcon, the system will automacally assign IPv4 address, IPv4 subnet mask,
IPv4 default gateway for the device.
HTTP
Set the HTTP port, DNS1 server address, and DNS2 server address.
9.14.8 Report Strategy
Sengs
You can set the center group for uploading the log via the EHome protocol.
On the Device for Management page, click → Network → Report Strategy to enter the Report
Strategy
Sengs tab.
You can set the center group and the system will transfer logs via EHome protocol. Click Save to
save the
sengs.
Center Group
Select a center group from the drop-down list.
DS-K1TA70 Series Face Recognion Terminal User Manual
199