HIKVISION DS-K1TA70 Series

Click Other → Face Recognion Terminal Parameters and you can congure the device
parameters.
Face Picture Database
Select Deep Learning as the face picture database.
Save Authencang Face Picture
If enabled, the captured face picture when authencang will be saved on the device.
CPU Card Reading
Select to read card No. or
le.
Work Mode
Set the device work mode as Normal Mode. You should authencate your credenal for
accessing.
ECO Mode
Aer enabling the ECO mode, the device will use the IR camera to authencate faces in the low
light or dark environment. And you can set he ECO mode threshold, ECO mode (1:N), and ECO
mode (1:1).
ECO Mode (1:1)
Set the matching threshold when
authencang via ECO mode 1:1 matching mode. The larger
the value, the smaller the false accept rate and the larger the false
rejecon rate.
ECO Mode (1:N)
Set the matching threshold when authencang via ECO mode 1:N matching mode. The larger
the value, the smaller the false accept rate and the larger the false rejecon rate.
ECO Mode Threshold
When enabling the ECO mode, you can set the ECO mode’s threshold. The larger the value, the
easier the device entering the ECO mode. Available range: 0 to 8.
Click Save to save the
sengs.
9.14.14
Congure Face Picture Parameters
Steps
1.
Click Maintenance and Management → Device to enter the device list.
2.
Click
to enter the remote conguraon page.
3.
Click Other → Face Picture Parameters to enter the
Conguring Face Picture Parameters page.
Pitch Angle
The maximum pitch angle when face authencaon.
Yaw Angle
The maximum yaw angle when face authencaon.
Margin (Le)
DS-K1TA70 Series Face Recognion Terminal User Manual
202