HIKVISION DS-K1TA70 Series

Note
●
You can also change the sengs in System Sengs.
●
If you install the device indoors near the window or the face recognion funcon is not
working well, select Others.
●
If you do not
congure the applicaon mode and tap Next, the system will select Indoor by
default.
●
If you
acvate the device via other tools remotely, the system will select Indoor as the
applicaon mode by default.
6.3 Set Network Parameters
Aer acvaon and select applicaon mode, you can set the network for the device
Steps
1.
Set the wired network parameters.
-
If enable DHCP, the system will assign the IP address and other parameters automacally.
-
If disable DHCP, you should set the IP address, the subnet mask, and the gateway.
Note
Make sure the device has connected to a network.
2.
Tap Next.
3.
Oponal: Tap Skip to skip network sengs.
6.4 Set Administrator
Aer device acvaon, you can add an administrator to manage the device parameters.
Before You Start
Acvate the device and select an applicaon mode.
Steps
1.
Oponal: Tap Skip to skip adding administrator if required.
2.
Enter the administrator's name (oponal) and tap Next.
DS-K1TA70 Series Face Recognion Terminal User Manual
30