HIKVISION DS-K1TA70 Series

9.14.12 Set Access Control Parameters
Steps
1.
On the Device for Management page, click
→ Others → Access Control Parameters to enter
the Access Control Parameters tab.
2.
Check the checkbox to enable the funcon.
Audio Prompt (Voice Prompt)
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
Upload Pictures aer Capturing
If you enable this funcon, the captured pictures will be sent to the client soware.
Save Captured Pictures
If you enable this funcon, the captured pictures will be saved.
Temperature Measurement Only
When enabling the funcon, the device will not authencate the permissions, but only take
the temperature. When disabling the
funcon, the device will authencate the permissions
and at the same me take the temperature.
Capture White Light Picture
When enabling the funcon, the pictures captured by the white light camera will be uploaded
to the
plaorm. If disabling the funcon, the device will only upload pictures captured by
thermographic camera to the plaorm.
Door Not Open When Detecng Abnormal Temperature
When enabling the funcon, the door will not open when the detected temperature is higher
or lower than the
congured temperature threshold. By default, the temperature is enabled.
Must Wear Face Mask
Aer enabling this funcon, the authencated person must wear a face mask, otherwise the
authencaon will be failed.
Over-Temperature Alarm
Edit the threshold according to actual situaon. If the detected temperature is higher than
the
congured parameters, an alarm will be triggered. The value should be between 35.1 ℃
and 44.9 ℃.
3.
Click Save.
9.14.13 Set Face
Recognion Terminal Parameters
Click Maintenance and Management → Device to enter the device list.
Press CTRL and click
to enter the remote conguraon page.
DS-K1TA70 Series Face Recognion Terminal User Manual
201