HIKVISION DS-K1TA70 Series User Manual

-
Disable DHCP, and you should set the IP address, subnet mask, and gateway manually.
Note
The device's IP address and the computer IP address should be in the same IP segment.
4.
Set the DNS parameters. You can enable Auto Obtain DNS, set the preferred DNS server and the
alternate DNS server.
7.2.2 Set RS-485 Parameters
The face recognion terminal can connect external access controller, secure door control unit or
card reader via the RS-485 terminal.
Steps
1.
Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2.
On the Communicaon Sengs page, tap RS-485 to enter the RS-485 tab.
Figure 7-5 Set RS-485 Parameters
3.
Select an peripheral type according to your actual needs.
DS-K1TA70 Series Face Recognion Terminal User Manual
39

HIKVISION DS-K1TA70 Series Specifications

General

Brand	HIKVISION
Model	DS-K1TA70 Series
Category	Touch terminals
Language	English