HIKVISION DS-K1TA70 Series User Manual

Note
The port number of the wireless network and wired network should be consistent with the port
number of ISUP.
8.
Select the Protocol Type as ISUP.
Note
If set the ISUP version as 5.0, you should create an ISUP key for the ISUP account.
9.
Set an account name for the network center.
10.
Click Save.
Set Device Capture Parameters
You can congure the capture parameters of the access control device, including manual capture
and event triggered capture.
Note
●
The capture funcon should be supported by the device.
●
Before seng the capture parameters, you should set the picture storage rst to dene where
the event triggered pictures are saved. For details, refer to Set Picture Storage in the user
manual of the client
soware. .
Set Triggered Capture Parameters
When an event occurs, the camera of the access control device can be triggered to capture
picture(s) to record what happens when the event occurs. You can view the captured pictures
when checking the event details in Event Center. Before that, you need to set the parameters for
the capture such as number of pictures captured for one
me.
Before You Start
Before
seng the capture parameters, you should set the picture storage rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3.
Select an access control device in the device list and select Linked Capture.
4.
Set the picture size and quality.
DS-K1TA70 Series Face Recognion Terminal User Manual
150

HIKVISION DS-K1TA70 Series Specifications

General

Brand	HIKVISION
Model	DS-K1TA70 Series
Category	Touch terminals
Language	English