HIKVISION DS-K1TA70 Series

You need to set Valid Authencaon Interval for this calculaon method. For example, if the
interval between card swiping of the same card is less than the set value, the card swiping is
invalid.
6.
Oponal: Set Enable T&A Status switch to on to calculate according to aendance status of the
device.
Note
This funcon should be supported by the device.
7.
Oponal: Enable Calculate Break Time into Aended Duraon.
Note
When enabled, break me will be calculated into the overall aendance duraon. That is, the
actual aendance duraon equals to the overall aendance duraon (includes break me).
8.
Set the related aendance me parameters as the following:
Start/End-Work Time
Set the start-work
me and end-work-me.
Valid Check-in/out Time
On the me bar, adjust the yellow bar to set the metable during which the check-in or
check-out is valid.
Calculated as
Set the duraon calculated as the actual work duraon.
Late/Early Leave Allowable
Set the metable for late or early leave.
9.
Set absence related parameters.
Check-In, Late for
You can set the late
me duraon for the employee who has checked in but is late for work. If
the employee exceeds the required
me period, his/her aendance data will be marked as
absent.
Check-Out, Early Leave for
You can set the early leave me duraon for the employee who checks out earlier than the
normal leave
me, and his/her aendance data will be marked as absent.
No Check-in
If the employee does not check in, his/her aendance data may be marked as absent or late.
No Check-Out
If the employee does not check out, his/her aendance data may be marked as absent or
early leave.
10.
Click Save to add the
metable.
11.
Oponal: Perform one or more following operaons aer adding metable.
Edit Timetable
Select a metable from the list to edit related informaon.
DS-K1TA70 Series Face Recognion Terminal User Manual
176