HIKVISION DS-KD9633-WBE6 - Network Settings

9.4.3 Network Sengs
TCP/IP Sengs
TCP/IP sengs must be properly congured before you operate the device over
network. The device supports IPv4.
Steps
1. Click Network → Basic
Sengs → TCP/IP to enter the sengs page.
Figure 9-7 TCP/IP Sengs
2. Select Network Card.
3.
Congure the network parameters.
-
Check DHCP, the device will get the parameters
automacally.
-
Set the IPv4 Address, IPv4 Subnet Mask and IPv4 Default Gateway manually.
4.
Congure the DNS server.
5. Edit Alarm Center IP and Alarm Host Port.
6. Click Save to enable the sengs.
Port
Sengs
Video Intercom Face Recognion Door Staon User Manual
65