HIKVISION DS-KH9510-WTE1(B) - Arming Mode Settings; 2.5 Password Settings

Note
●
When you forget the gesture password, you can tap Forgot Gesture Password
or Use admin password to enter admin password to unlock.
●
When you tap Sengs → Advanced Sengs to disable Unlock by Gesture, you
can skip the step.
2.4 Basic Sengs
Basic sengs is required before starng using the indoor staon. It is necessary to
set the indoor
staon network, room No., linked devices, device me display, and so
on.
2.4.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network
parameters aer acvang the indoor staon. Only when the IP address of the
indoor
staon is in the same network segment as other devices, it can work properly
in the same system.
Before You Start
Wake up the device. Refers to Wake Up the Device for details.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1. On the main page of the device, tap Sengs → Advanced Sengs → Network
Sengs to enter the network sengs page.
Note
Admin password is required to enter the advanced sengs page.
Video Intercom 9 Series Indoor Staon Conguraon Guide
8