HIKVISION DS-KH9510-WTE1(B) - 3 Remote Operation via the client software; 3.1 Activate Device Remotely; 3.2 Device Management

3 Remote Operaon via the client
soware
The Video Intercom module provides remote control and conguraon on video
intercom products via the iVMS-4200 client
soware.
3.1 Acvate Device Remotely
You can only congure and operate the indoor staon aer creang a password for
the device acvaon.
Before You Start
Default parameters of indoor staon are as follows:
●
Default IP Address: 192.0.0.64.
●
Default Port No.: 8000.
●
Default User Name: admin.
Steps
1. Run the client
soware, enter Device Management, check the Online Device
area.
2. Select an
inacvated device and click the Acvate.
3. Create a password, and conrm the password.
Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 characters, including at least three kinds of following
categories: upper case leers, lower case leers, numbers, and special characters)
in order to increase the security of your product. And we recommend you change
your password regularly, especially in the high security system, changing the
password monthly or weekly can
beer protect your product.
4. Click OK to acvate the device.
3.2 Device Management
Device management includes device acvaon, adding device, eding device, and
deleng device, and so on.
Video Intercom 9 Series Indoor
Staon Conguraon Guide
34