HIKVISION DS-KH9510-WTE1(B) - 3.4.3 Network

Figure 3-17 Debugging Sengs
Check the checkbox to enable android debug bridge. Click Save to enable sengs.
3.4.3 Network
Local Network Conguraon
Steps
1. Click Local Network
Conguraon to enter local network conguraon page.
Figure 3-18 Local Network Conguraon
2. Enter the local IP address, subnet mask, gateway address, and port No.
3. Click Save to enable the sengs.
Note
●
The default port No. is 8000.
●
Aer eding the local network parameters of device, you should add the
devices to the device list again.
Video Intercom 9 Series Indoor Staon Conguraon Guide
51