Mobile Video Recorder User Manual
28
protection is disabled.
● When the device power voltage is lower than the system threshold, the device will shut down
automatically, no matter what type of startup/shutdown mode you selected.
3. Select Auto Work Type as Halt Delay.
4. Select Delay Time.
5. Click Save.
6.3 Configure G-Sensor Alarm
G-Sensor detects and records acceleration information in 3-axial (X, Y, Z) directions.
Before You Start
Connect a G-sensor to the device.
Steps
1. Go to Configuration → Vehicle → G-Sensor.
Figure 6-2 Configure G-Sensor
2. Select module according to actual situation.
External
The G-sensor is connected to the device via RS-232/RS-485 interface.
Built-in
The G-sensor is a built-in module of the device.
3. Set the limit value for acceleration alarm in X, Y, and Z directions.
Note
X, Y, and Z represent the directions of acceleration and the unit of alarm value is G (G=9.8 m/s
2
).
To Next Page
Loading...
Need help?
General