Mobile Video Recorder User Manual
50
Chapter 12 Local Menu Operation
Connect a display and a mouse to the recorder, and you can operate the recorder locally.
12.1 Manage IP Camera
After connecting IP camera(s) or positioning system lite to the device, if no image is displayed on
live view interface, follow the instructions below to manage IP camera(s) or positioning system lite.
If image can be displayed normally on live view interface, ignore this section.
Note
The section is only available for the device supporting IP camera or positioning system lite.
12.1.1 Add IP Camera Automatically
After the IP camera is connected, the recorder can add it automatically.
Before You Start
● The recorder supports adding IP camera automatically.
● Connect the IP camera to the corresponding interface of the recorder.
● Make sure the IP camera is inactive or its password is the same as that of the recorder.
Steps
1. Go to Menu → Other Settings → Camera Management.
2. Check IP PNP PORT.
3. Click OK.
12.1.2 Manage IP Camera Manually
If the connected IP camera has been activated, but the password is different from that of the
recorder, you can manage the IP camera manually.
Activate IP Camera
Before adding an IP camera, activate it by setting a password for it.
Before You Start
Connect the IP camera to IP camera interface on the recorder rear panel.
Steps
1. Go to Menu → Other Settings → IPC Settings.
2. Uncheck Auto Add and select Set of Manage IP Camera.
To Next Page
Loading...
