Mobile Video Recorder User Manual
37
Chapter 9 Events and Alarms
9.1 Configure Motion Detection Alarm
When motion detection alarm is configured, once a motion event is detected, the device starts to
record and multiple linkage actions will be triggered.
Steps
1. Go to Configuration → Event → Basic Event → Motion Detection.
2. Select Channel No.
3. Draw detection area.
1) Click Draw Area.
2) In preview area, drag to draw the detection area.
3) Click Stop Drawing.
4. Configure arming schedule. For detailed steps, refer to Configure Arming Schedule.
5. Configure linkage method. For detailed steps, refer to Configure Linkage Actions.
6. Set Sensitivity.
7. Click Save.
9.2 Configure Video Loss Alarm
When the recorder cannot receive video signal from the analog cameras, the video loss alarm will
be triggered. Linkage actions, including audible warning and alarm output, can be set to respond.
Steps
1. Go to Configuration → Event → Basic Event → Video Loss.
2. Check Enable Video Loss Detection.
3. Configure arming schedule. For detailed steps, refer to Configure Arming Schedule.
4. Configure linkage method. For detailed steps, refer to Configure Linkage Actions.
5. Click Save.
9.3 Configure Video Tampering Alarm
A tampering alarm is triggered when the camera is covered and the monitoring area cannot be
viewed. Linkage actions, including audible warning, alarm output, can be set to respond.
Steps
1. Go to Configuration → Event → Basic Event → Video Tampering.
2. Select Channel No.
3. Draw detection area.
To Next Page
Loading...
Need help?
General