Mobile Video Recorder User Manual
29
During driving, the device will alarm when acceleration of any direction exceeds the set value.
4. Optional: Set vehicle detection if you want to detect sharp curve, collision, turnover, etc. and
trigger alarm when these behaviors are detected.
1) Check Vehicle Detection.
2) Check the detection(s) according to the actual needs.
3) Enter duration and threshold for the detection(s).
When the vehicle moving exceeds the set threshold, and the detected behavior duration
exceeds the set duration, alarm and record will be triggered.
5. Select the axis indicating the driving direction according to the diagram.
6. Check the linkage actions for acceleration alarm, including Audible Warning and Trigger Alarm
Output.
7. Click Save.
6.4 Configure Sensor-In
Sensor-in detects and records the driving information of the vehicle, including pedal braking,
turning left/right, reversing, etc.
Before You Start
Connect the sensor-in interface to vehicle corresponding interface. For details, refer to Quick Start
Guide.
Steps
1. Go to Configuration → Vehicle → Sensor-In.
2. Check Enable.
Note
If sensor-in is disabled, you can configure it via alarm input. For example, for the recorder with
4-ch alarm inputs, according to the sequence of the parameters on the interface, braking
corresponds to No. 5 alarm input (A<‐5), turning left corresponds to No. 6 alarm input (A<‐6),
and so on. Refer to "Configure Alarm Input" for details.
3. Select Trigger Level and Pop Channel according to actual situation.
The image of selected channel will be displayed in full screen when sensor-in is triggered.
4. Click Save.
To Next Page
Loading...
Need help?
General