HIKVISION DS-TCG406-E - 12.2 Set IP Address Filtering; 12.3 Enable User Lock; 12.4 Set HTTPS Security; 12.4.1 Create Self-signed Certificate

3.
Set Filtering Mode.
Blocklist Mode
The added IP addresses are not allowed to access the device.
Allowlist Mode
The added IP addresses are allowed to access the device.
4.
Click Add, enter the IP address, and click OK.
Note
The IP address only refers to the IPv4 address.
5.
Oponal: Edit, delete, or clear the added IP addresses.
6.
Click Save.
12.3 Enable User Lock
To raise the data security, you are recommended to lock the current IP address.
Steps
1.
Go to Conguraon → System → Security → Security Service → Soware .
2.
Enable user lock.
3.
Click Save.
Result
When the
mes you entered incorrect passwords have reached the limit, the current IP address
will be locked automacally.
12.4 Set HTTPS
12.4.1 Create and Install Self-signed Cercate
HTTPS is a network protocol that enables encrypted transmission and identy authencaon,
which improves the security of remote access.
Steps
1.
Go to Conguraon → Network → Network Parameters → HTTPS .
2.
Select Create Self-signed
Cercate.
3.
Click Create.
4.
Follow the prompt to enter Country/Region, Domain/IP, Validity, and other parameters.
5.
Click OK.
Result
The device will install the self-signed
cercate by default.
Intelligent Entrance ANPR Camera User Manual
63