HIKVISION DS-TCG406-E - 7.1.3 Set SDK Listening; 7.1.4 Set Arm Host Upload; 7.1.5 Set ISAPI Listening

7.1.3 Set SDK Listening
The SDK listening can be used to receive the uploaded informaon and pictures of the device
arming alarm.
Before You Start
The listening service has been enabled for the SDK listening, and the network
communicaon with
the device is normal.
Steps
1.
Go to
Conguraon → Network → Data Connecon → SDK Listening .
Figure 7-3 Set SDK Listening
2.
Check Enable SDK Listening.
3.
Set IP Address/Domain and Port if you need to upload the alarm informaon and pictures.
4.
Oponal: Enable the picture uploading listening if you need to upload image informaon.
5.
Oponal: If you want to save the alarm informaon and pictures to the cloud storage, click to
set Cloud Storage. Refer to
Set Cloud Storage for details.
6.
Click Save.
7.1.4 Set Arm Host
The device can upload the captured pictures via the arm host.
Intelligent Entrance ANPR Camera User Manual
35