HIKVISION DS-TCG406-E - Page 42

Steps
1.
Go to Conguraon → Network → Data Connecon → FTP .
Figure 7-2 Set FTP
2.
Check Enable FTP.
3.
Select Number of Enabled FTP.
Note
You can only enable one FTP.
4.
Set FTP Parameters.
1) Select Sever Address Type and enter corresponding informaon.
2) Enter Port.
3) Enter User Name, Password, and conrm the password.
4) Select Protocol Type.
5) Select Directory Structure.
Note
You can customize the directory structure according to your needs.
5.
Select Path/Picture Name Encoding Mode.
UTF-8
UNICODE encoding.
6.
Oponal: Enable upload funcons.
Not Upload Plate Close-up
The close-up pictures of a license plate will not be uploaded.
Upload Addional Informaon to FTP
Add related informaon when uploading data to the FTP server.
7.
Oponal: Click FTP Test to check the FTP server.
8.
Set naming rules and separators according to the actual needs.
9.
Oponal: Edit OSD informaon which can be uploaded to the FTP server with the pictures to
make it convenient to view and disnguish the data.
10.
Click Save.
Intelligent Entrance ANPR Camera User Manual
34