HIKVISION DS-TCG406-E - 8.4 Set ROI (Region of Interest)

8.4 Set ROI
ROI (Region of Interest) encoding helps to assign more encoding resources to the region of
interest, thus to increase the quality of the ROI whereas the background informaon is less
focused.
Before You Start
Please check the video encoding type. ROI is supported when the video encoding type is H.264 or
H.265.
Steps
1.
Go to
Conguraon → Video → Video Encoding → ROI .
Figure 8-2 Set ROI
2.
Select Stream Type.
3.
Set ROI region.
1) Check Enable.
2) Select Area Code.
3) Click Draw Area.
4) Drag the mouse on the live view image to draw the
xed area.
5) Select the
xed area that needs to be adjusted and drag the mouse to adjust its posion.
6) Click Stop Drawing.
4.
Enter Area Name and select ROI Level.
Note
The higher the ROI level is, the clearer the image of the detected area is.
Intelligent Entrance ANPR Camera User Manual
46