HIKVISION DS-TCG406-E - Chapter 7: Record and Capture Management; 7.1 Set Storage Path; 7.1.1 Set Memory Card; 7.1.2 Set FTP Upload

Chapter 7 Record and Capture
7.1 Set Storage Path
7.1.1 Set Memory Card
If you want to store the les to the memory card, make sure you insert and format the memory
card in advance.
Before You Start
Insert the memory card to the device.
Steps
1.
Go to
Conguraon → Storage → Storage Management → HDD Management .
Figure 7-1 Set Memory Card
2.
Format the memory card in two ways.
-
Check the memory card, and click Format to format it manually.
Note
For the newly installed memory card, you need to format it manually before using it normally.
-
If you want to format the memory card automacally when the card is abnormal, check Auto-
Inialize
Redundant Storage.
3.
Oponal: If the device has been connected to the plaorm, and you want to upload the
memory card
informaon automacally, check Auto-Upload Data in Redundant Storage and set
Interval to upload.
4.
Click Save.
7.1.2 Set FTP
Set FTP parameters if you want to upload the captured pictures to the FTP server.
Before You Start
Set the FTP server, and ensure the device can communicate normally with the server.
Intelligent Entrance ANPR Camera User Manual
33