HIKVISION DS-TCG406-E - 4.1.3 Set Wiegand Parameters

Parking Detecon
Enable the funcon and set Judgment Time. If a vehicle has been parked for a duraon
longer than the set judgment me, the parking informaon will be upload.
3.
Set the relay funcon.
Note
The supported number of relays varies with dierent models. Relay 1 corresponds to the 1A and
1B of the terminal. Relay 2 corresponds to the 2A and 2B of the terminal.
4.
Select IO Funcon for the corresponding barrier gate related I/O. The device will upload barrier
gate status
informaon for convenient exit and entrance management.
Note
●
If the device only have one I/O interface, and the trigger type is I/O Coil, the barrier status
cannot be congured.
●
If the trigger type is Radar Mixed Trac and the forward radar and backward radar are
selected, the corresponding barrier gate related I/O
funcon cannot be congured. E.g., the
forward radar is IO1 and the backward radar is IO2. Then the barrier gate related IO1 and IO2
funcons cannot be congured.
5.
Set the barrier gate operaon and alarm operaon for the temporary vehicles, vehicles in the
blocklist, and vehicles in the allowlist in Vehicle Informaon Management.
Upload via SDK
Check Upload via SDK to arm and upload the vehicle
informaon to the arming terminal via
SDK.
Upload to Alarm Host
If the device has been connected to the alarm device, check Upload to Alarm Host. When the
barrier gate is open, the alarm device will be triggered to alarm.
6.
Oponal: You can click Close, Open, Unlock, or Lock to control the barrier gate remotely.
Note
The funcons of remote control of barrier gate vary with dierent models. The actual device
prevails.
7.
Click Save.
4.1.3 Set Wiegand Parameters
The device can get access to the access control system or other system
supporng Wiegand
protocols to send data in the entrance and exit scenes.
Steps
1.
Go to
Conguraon → Capture → Entrance and Exit → Wiegand Parameters .
2.
Check Enable.
Intelligent Entrance ANPR Camera User Manual
23