HIKVISION DS-TCG406-E - 13.7 Set DST (Daylight Saving Time); 13.8 Debugging Functions; 13.8.1 Debug Device; 13.8.2 Vehicle Capture and Recognition Service

13.7 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1.
Go to Conguraon → System → System Sengs → DST .
2.
Check Enable DST.
3.
Set Start Time, End Time, and DST Bias.
4.
Click Save.
13.8 Debug
Note
The debug conguraons below are only provided to debug the device by the professionals.
13.8.1 Debug Device
You can enable the funcons to debug the device.
Steps
1.
Go to Conguraon → Capture → Advanced → System Service .
2.
Check the debug informaon according to your needs.
Note
The supported parameters vary with dierent models. The actual device prevails.
Enable Algorithm POS Informaon Debug
The algorithm POS informaon will be overlaid on the playback image when you play back
the video with the dedicated tool.
3.
Click Save.
13.8.2 Vehicle Capture and
Recognion Service
Set the vehicle capture and recognion service to debug the device.
Steps
Note
The funcon varies with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Advanced → Vehicle Capture and Recognion Service .
Intelligent Entrance ANPR Camera User Manual
69