HIKVISION DS-TCG406-E - Chapter 10: Serial Port Configuration; 10.1 Set RS-485 Parameters; 10.2 Set RS-232 Parameters

Chapter 10 Serial Port Conguraon
10.1 Set RS-485
Set RS-485 parameters if the device has been connected to a vehicle detector or other RS-485
devices.
Before You Start
The corresponding device has been connected via the RS-485 serial port.
Steps
Note
The number of available RS-485 serial port varies with dierent models.
1.
Go to Conguraon → System → System Sengs → Serial Port → RS-485 .
2.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3.
Set Work Mode.
Transparent Channel
Select it when the other peripheral devices are connected to the RS-485 serial port of the
device for
communicaon transmission.
4.
Click Save.
10.2 Set RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
have been connected.
Before You Start
The debugging device has been connected via the RS-232 serial port.
Steps
1.
Go to
Conguraon → System → System Sengs → Serial Port → RS-232 .
2.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3.
Select Work Mode.
Console
Intelligent Entrance ANPR Camera User Manual
59