HIKVISION DS-TCG406-E - Page 32

Figure 4-3 Set Wiegand Parameters
3.
Select Communicaon Direcon.
Send
The barrier gate can be connected to the device via Wiegand 26, Wiegand 34, Wiegand 72, or
Wiegand sha1 26 protocol.
4.
Select Wiegand Mode.
Wiegand 26
It is applicable to all the access control projects. The device will get the card No. (pure
numbers with no more than 8 digits) from the allowlist and blocklist related to the captured
license plate number and send the card No. to the access control system or other system
supporng Wiegand protocols via Wiegand 26 protocol.
Wiegand 34
It is applicable to all the access control projects. The device will get the card No. (pure
numbers with no more than 10 digits) from the allowlist and blocklist related to the captured
license plate number and send the card No. to the access control system or other system
supporng Wiegand protocols via Wiegand 34 protocol.
Wiegand 72
It is a non-standard Wiegand protocol. The device will get the card No. (up to 9 characters
only including 0 to 9, uppercase, or lowercase can be sent) from the allowlist and blocklist
related to the captured license plate number and send the card No. to the access control
system or other system
supporng Wiegand protocols via Wiegand 72 protocol.
Wiegand sha1 26
It is a non-standard Wiegand protocol. The captured license plate number will be encrypted
via sha1. The last low 24 bits
aer encrypon will be get as the data bits. The high 12-bit
parity check bits will be added before the highest bit. The low 12-bit parity check bits will be
added
aer the lowest bit. The bit stream composed with 26 bits will be sent to the access
control system or other system supporng Wiegand protocols.
5.
Click Save to save the
sengs.
Intelligent Entrance ANPR Camera User Manual
24