Specifications
Chapter 1: Introduction
Electrically Operated General Ward Bed Page 1 - 21
Operation and Maintenance Manual (154588 REV 1)
1
The electromagnetic emissions and immunity guidance is given below:
Electromagnetic Emissions Guidance
Guidance and Manufacturer's Declaration—Electromagnetic Emissions
The bed is intended for use in the electromagnetic environment specified below. The customer or the user of the bed
should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment—Guidance
RF Emissions
CISPR 11
Group 1 The bed uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class A The bed is suitable for use in all establishments other than
domestic and those directly connected to the public low-
voltage power supply network that supplies buildings used
for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations / flicker
emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
Need help?
General
