194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use Page 61
Mobilizing the patient
b. Select the location of the room in the
facility (up to four levels, including the
room, e.g., building, ward, etc.).
c. Select the room number (e.g., Ng-09-14) or
another location by pressing Different
Location.
d.
If the room is not already associated with
an Available bed, the locating process
l
ooks for the selected room (flashes).
e.
The server has identified the room and the
room number appears.
f. If the room is already associated with an
Assigned
bed, a screen opens.
g. Press Continue t
o confirm this choice and
the assignment process starts.
h. The system then informs the previously
a
ssigned bed.
Assignment of the patient ID to the bed.
Check that the “Patient Id Display” mode is active (see “Setting the Wi-Fi options”
page 54). Only applies to the Hillrom™ Digital Health Gateway.
This procedure is only possible if the following three conditions are met: the bed has
been located, the server proposes a patient name for this room and the patient is in
the bed.
1. Press Parameters on the GCI.
the press Connectivity
or
Press the status bar of the Wi-Fi and location
in
formation.
2. Press Check identity.
To Next Page
Loading...
Need help?
General
