Hillrom Compella - Single Mode Bed Exit Alert System Operation; Activating the Bed Exit Alert System

Standard Features
Compella™ Bariatric Bed System Instructions for Use (178951 REV 6) 35
5. Repeat Step 3 and Step 4 on the other side of the bed.
NOTE:
After you have manually retracted the bed width, gently pull on each siderail to make sure that the slide
plates are locked in position.
To manually extend the bed—do these steps in this order:
CAUTION:
Caution—Immediately after you manually extend the bed width, use the air supply unit to inflate the
side bolsters to fill in the gap between the siderails and the surface. See
“Deflate and Inflate the Side
Bolsters and Foot Section” on page 65
1. Pull the release lever below the intermediate siderail toward you as you pull outward on the
intermediate siderail as far as it will go.
2. Pull the release lever below the head siderail toward you as you pull outward on the head siderail
as far as it will go.
3. Repeat steps 1 and 2 on other side of bed.
NOTE:
After you have manually extended the bed width, gently push each siderail inward to make sure that
the slide plates are locked in position.
If power is restored to the bed, and you have not completed all width adjustments, these will occur:
• Both indicators next to the Retract and Extend Width controls will flash if the bed is not in the
correct position and will continue to flash until the bed is fully extended or fully retracted.
• A triple beep will sound every 10 seconds until the bed is adjusted to the fully extended or
fully retracted position.
• Err 6 will flash on the caregiver control pod until the bed is fully
extended or fully retracted.
• If after 2 minutes the bed width has not been fully adjusted, a
continuous triple beep will sound until the bed reaches the fully
extended or fully retracted position.
• Fully extend or fully retract bed width to clear the Err 6 code and
silence the triple beep.
• Once the bed is fully extended or retracted, the indicator will come on solid and a single
confirmation beep will sound.
NOTES:
• If the bed is not fully retracted or fully extended, you will not be able to raise the head of the
bed; you will only be able to lower it.
• When power is restored, you can use the powered width controls to make the final adjustments.
FlexAfoot™ Bed Length Adjustment
CAUTION:
To help prevent equipment damage, obey these cautions:
• Caution—When you lengthen or shorten the foot end of the bed, make sure that the magnets
on the surface power cord do not interfere with the movement.
• Caution—Do not adjust the bed length when traction equipment is in use.