Hillrom Compella - Communication System; Nurse Call Control Operation

Patient Transport
Compella™ Bariatric Bed System Instructions for Use (178951 REV 6) 39
Engage Transport Mode
Transport
WARNING:
To help prevent personal injury and/or equipment damage, obey these warnings:
• Warning—When you transport the bed without the IntelliDrive® XL Transport System engaged,
make sure the bed is at a sufficient height for the drive wheels to clear ramps and inclines that
are greater than 3°.
• Warning—During the transport, use caution so that the bed does not tip or overbalance.
1. Grip one or both of the push handles that are at the head end of the bed.
1. Access the transport pod at the patient head-right
corner of the bed.
2. Adjust the transport pod into a position for easy
access.
3. Press the green Transport control (1) to lower the bed to the
transport position (the power drive wheels on the ground). When the
bed reaches the Transport position, you will hear a single beep, and
the amber Transport indicator on the transport pod will turn green.
NOTES
• If the Bed Up/Down function is locked out, you will hear a triple
beep. Deactivate the lockout so that you can lower the bed height
from the transport pod.
• To put the bed in transport mode, you must use the transport
pod.
4. Step down on the green Steer pedal to release the brake and activate
steer. The amber brake/steer pedal indicator (2) on the transport pod
will turn green.